XciteRC 14000110 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 16)

16 14000000 XciteRC Flybarless 3D 20014000000 XciteRC Flybarless 3D 200

Getting started

Introduction

As you are about to see, the Xcite Flybarless 3D 200 truly is an ultra micro heli experience unlike any other.

Its advanced ﬂybarless design reduces drag on the rotor head and more importantly, under the precision in

the three-axis gyroscope complement of self-control, it greatly increases stability of the body. This, combined

with its exceptionally lightweight airframe, delivers a level of power and responsiveness that eclipses that of

any ultra micro heli you have ﬂown before.

Inverted ﬂight, loops, lips, rolls,funnels, wash pot- the Flybarless 3D 200 can do it all, indoors or out, with

power to spare. If you‘re transitionjng from a basic CCPM or ﬁxed pitched heli, you‘ll ﬁnd the Flybarless 3D

200 is a great way to get used to ﬂying mora agile CCPM helis without having to invest a lot in expensive

equipment or repairs.

Before you take the ﬁrst ﬂight, please take time to read through this manual. lt contains important pre-ﬂight

information as well as useful tips on binding your transmitter that will help ensure your ﬁrst ﬂight is a great one.

Helicopter Parameters

Length 200 mm

High 80 mm

Weight 37 g

Rotating propeller diameter 204 mm

TailRotor blade Diameter 36 mm

Battery Speciﬁcation 3.7 V 180 mAh 15C

Flight time 4 to 5 min

Battery charging

• Connect charger to the USB port of computer by using USB Line.

• Connect the Li-po battery to the Charger by using Charger conversion wire, at this time. the charging

indicator light shows red. When the battery is full, the light turns green.

• The Charger can charge two batteries at the same time, and if no battery connect, the green light bright.

Notice: Only use the charger delivered with the helicopter.

WARNING: Never attempt to power the charger from an AC outlet without the use of a proper ACto DC

adapter/power supply. - ﬁre hazard!

First Flight preparation

• Make sure the battery power Is full both for TX and helicopter

• Before open the power of TX, please make sure the TH. Stick at the bottom and the switch of TH.HOLD

and 3D mode in back position (back cover direction).

• Make sure the TX is binding with helicopter, or please rebind them.

• Please open TX ﬁrst, then connect the battery with the RX board on helicopter to bind with TX. When

close, please cut the power of helicopter ﬁrst, and then turn off the TX.

• Flying in a suitable area, away from people, cars, electric pylon, pool and so on.

14000000-Flybarless-3D-200-Anleitung.indd 16 24.10.2013 14:36:35

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Keine Kommentare

XciteRC 14000110 Anleitung zur Fehlerbehebung Seite 16