XciteRC Flybar 180SC Betriebsanleitung PDF herunterladen (Seite 19)

XciteRC Flybar 180SC Coax

Camera Operation · Maintenance · Troubleshooting

The data can be transferred via the micro SD memory card or via the USB socket and a suitable cable to

the PC.

You can capture single pictures or video. Once you press

the button for pictures, the red camera light goes on, the

camera takes a picture. Press the video button to start

the video recording which runs until you press the button

again. The red LED lights up while recording.

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good

condition and to minimize wear.

• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a

harder brush or a toothbrush can be used.

• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic

of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up

liquid.

• Check the tightness of all screws and tighten if necessary.

• Also check all connections, cables and power battery / rechargeable battery for damage.

•

WARNING: Damaged batteries or rechargeable batteries must not be used again and must be

disposed of immediately – ﬁre hazard! Please note the disposal notes at the end of this manual.

• Check the model for worn, broken or jammed parts and gears and repair if necessary.

•

WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in

use – ﬁre hazard!

Troubleshooting

Problem Possible Cause Corrective Action

Rotor don‘t move ON/OFF switch is OFF

Weak helicopter battery

Switch ON helicopter

Re-charge battery

Rotor stops sud-

denly, helicopter

chrashes

Weak helicopter battery Re-charge battery

Picture

Video

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Keine Kommentare

XciteRC Flybar 180SC Betriebsanleitung Seite 19